Waterjet Group

Welcome to the ultimate waterjet forum, WaterjetGroup.com!
This forum will give you access to participate in discussions and attain resources via our vibrant waterjet community . This discussion board is intended for any waterjet user but the majority of the moderators are associates of Flow International Corporation. We will attempt to make this community an unbiased source of information regarding general waterjet topic areas. If you are a registered Flow Waterjet customer and require in-depth product support, please visit FlowParts.com.

Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: FlowJet 2b Computer issues and upgrades


Member

Status: Offline
Posts: 15
Date:
FlowJet 2b Computer issues and upgrades
Permalink  
 


We've had our Flow unit for about 3 1/2 years now and have had a issue slow occur on a more frequent basis.  While the FlowCut software is running and the unit is actively cutting, it will stop and shut the pump down.  No error. We can start the pump back up and continue cutting from that point.  It used to happen once in a great while and now is more frequently, at least one a day.  Has anyone else had this issue?

 

Also, the computer on our machine runs Windows XP as its operating system.  Has anyone upgraded there machine to Windows 7 or higher and if so is it worth it? 

 

Jim



__________________
TAD


Newbie

Status: Offline
Posts: 3
Date:
Permalink  
 

I had the same thing happen. I just went through my emails and did not find where they had answered me on that particular problem because we had quite a few of issues going on. But, to fix a bigger issue we had, they ended up replacing the PMAC card. Haven't had it happen again.

__________________


Newbie

Status: Offline
Posts: 4
Date:
Permalink  
 

I am having the same computer problem with my machine. It will cut then all of a sudden the program freezes and the pump will still work. Flow is telling me to upgrade my computer for $14000.00 plus . I do not think its the computer that is causing this issue. I am looking at the pmac board may be the problem. $2200.00 . I will keep you updated when I change out the pmac board.



__________________


Newbie

Status: Offline
Posts: 2
Date:
Permalink  
 

What you are experience is problems with the P-Mac card. Change it out and you should be good to go.

__________________


Newbie

Status: Offline
Posts: 4
Date:
Permalink  
 

That is exactly what I did . I change the pmac card and I am good to go. No thanks to flow tech.

__________________


Member

Status: Offline
Posts: 11
Date:
Permalink  
 

Question

Do you have a earth ground connected to your machine?

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 



__________________
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Please note, the views and recommendations expressed by employees of Flow or it's partners on this website do not necessarily represent those of Flow International Corporation. For more information on this site's Terms of Use , please visit the DXF Copyright and Community Guidelines pages.

Important: Do not upload any DXF's or images without permission unless they consist entirely of content you or your company created.

By clicking "Upload file", you are representing that this DXF or image does not violate the WaterjetGroup.com's forum's Terms of Use and that you own all copyrights to this file or have authorization to upload it.